10.0.0.10 - Router Login & Default Password

10.0.0.10 is a private IP address that certain Piso WiFi machines use as their admin login page. It's close to the more common 10.0.0.1, but some firmware versions pick this address instead.

To log in, connect to the machine's WiFi, open your browser, and type `http://10.0.0.10` in the address bar. The default username and password are both `admin`.

Which Devices Use 10.0.0.10?

This address shows up mainly in the Piso WiFi market. Specific firmware assigns it instead of the standard .1 address:

• LPB Piso WiFi - some firmware versions
• Vendo WiFi machines - select older models
• Routers on larger local networks - when 10.0.0.1 through .9 are already taken, some devices auto-assign .10

If you run multiple Piso WiFi machines on a shared network, each one needs a unique IP. Operators sometimes use addresses like 10.0.0.10 on purpose to avoid conflicts.

How to Log In to 10.0.0.10

1. Connect to the right WiFi. Your phone or laptop must be on that machine's network. Don't use another router or mobile data.
2. Open a browser. Chrome, Firefox, or Edge all work.
3. Type `http://10.0.0.10` directly into the address bar. Skip the search field.
4. Enter credentials. Use `admin` / `admin` for most machines. Check the device label if the default doesn't work.

One thing that trips people up: browsers sometimes auto-redirect to `https://10.0.0.10`, which won't work because Piso WiFi machines don't use HTTPS. Always type the full `http://` prefix.

Default Login Credentials

Device	Username	Password
LPB Piso WiFi	admin	admin
Vendo WiFi	admin	admin
Generic / unknown	admin	Check device label

10.0.0.10 vs. Other Piso WiFi Addresses

The 10.0.0.x range is used across many Piso WiFi machine models. Which address your machine responds to depends on the firmware:

• 10.0.0.1 - most widely used
• 10.0.0.0.1 - LPB and newer Vendo standard
• 10.0.0.10 - select firmware versions
• 10.0.0.2 - some models as secondary address

If 10.0.0.10 doesn't respond, try the other addresses on the list. The correct one is usually printed on the machine's label or included in the setup guide from your supplier.

When 10.0.0.10 Doesn't Work

No response at all. You're on the wrong network or mobile data is still active. Switch WiFi connections and try again.

Login rejected. Someone changed the default credentials. A factory reset brings them back, but it also erases all custom settings including pricing rules. Keep that in mind before you press the reset button.

Connects but shows another device. Another machine on the same network might have taken 10.0.0.10 as its address. Log in to your main router at 10.0.0.1 and check the connected devices list to find the correct IP.